In this guide
Material care / Salomon membrane shoes
How to clean compatible Salomon GORE-TEX running shoes
For ordinary dirt on compatible Salomon textile running shoes with a confirmed GORE-TEX membrane, follow Salomon’s clean-water route: loosen the shoe, separate removable insoles, rinse and use a soft brush or sponge, then dry fully before reassembly. Do not add soap or washing powder.
Prepare the water and drying area
- Access to clean running water.
- A soft brush or sponge suitable for the pair.
- A ventilated indoor place for the shoes and removable insoles to dry.
- Your exact pair’s care information.
Leave soap, washing powder and the washing machine out of this route. A general membrane-care article does not replace the shoe maker’s instructions. Resolve an unclear model or component before starting with water.
Clean in 4 steps
Loosen the shoe and check removability
Loosen the laces or Quicklace as appropriate. Remove the insoles only when they are designed to come out. If an insert resists, stop and check the pair’s directions rather than pulling it free.
Rinse and clean the outside
Salomon describes rinsing under running water and using a soft brush or sponge for remaining dirt. Keep the work on the confirmed exterior. This guide adds no soaking, hard scraping or interior-cleaning procedure.
Original explanatory drawing. Drops indicate water, not a required pressure or flow. The brush meets the outside panel; the drawing is not a specific Salomon model or a membrane-identification guide. Pause as you work: if the surface changes, parts separate or the remaining material is not ordinary dirt, stop before increasing force or adding a product.
Dry the parts separately
Rinse permitted removable insoles separately and let them dry. Leave the shoes in a ventilated room at room temperature, away from direct sun and heat sources. This guide gives no drying deadline.
Check before putting the pair back together
Wait until the shoes and insoles are fully dry before refitting and re-lacing. Inspect inside as well as outside. If a part is still damp, continue the permitted drying setup; do not pack it away to meet a deadline.
Check membrane aftercare separately
Salomon discusses exterior aftercare for membrane-equipped running shoes, with the timing and use determined by the treatment’s instructions. That is a separate decision from this basic clean. Confirm both shoe and product compatibility before using anything; this page supplies no spray distance, application dose or heat-activation method.
When this route stops
Unknown material, resistant insert or different model directions: pause and resolve the instructions first.
Damage, color or finish change, sharp debris or unusual contamination: stop the ordinary clean and ask the maker about the specific condition.
Persistent wetness, odor or suspected leakage: this is not a diagnosis, disinfection method or waterproofness test. Do not substitute a spray for identifying the problem.
Common mistakes
- Adding a generic sneaker soap mixture to this maker-specific route.
- Using clothing heat-reactivation advice for a shoe.
- Pulling out a fixed insert or assuming the lining cannot get wet.
- Treating drying, cleaning and membrane aftercare as interchangeable tasks.
Sources & how this guide was made
- Salomon UK: How to clean your running shoes — published April 2, 2020; updated February 25, 2026. Operational source for the cleaning, drying, restrictions and membrane-aftercare boundary.
- GORE-TEX consumer footwear care — shoe-maker instructions remain necessary. General detergent guidance here is not substituted for Salomon’s route; no article date displayed.
Originals reviewed November 3, 2026. AI-assisted desk research and original explanatory illustrations for YourShoesBox. Model/material matching and stopping checkpoints are editorial aids. No actual pair examined, practical cleaning test, leak test, expert endorsement or reader outcome claimed.
Related guides
Help us make this guide clearer
Found an unclear step, a broken link or a possible care error? Your email draft includes this guide’s title and link. Add the step or issue before sending.